Download Gemini User Guide - Ag Tech Services

9
The FieldLevel II Plugins
The system performs its calibration sequence to test the speed at which the blade raises
and lowers. This process takes approximately 8 – 10 minutes.
To manually calibrate the valve, enter values in the three Manual Calibration fields and then
tap OK.
Operating the Tandem/Dual plugin
Blade height indicators
Once you install and configure tandem mode (two implements each with a GPS receiver), or
dual mode (a single implement with a GPS receiver at each end), a second blade height
indicator appears on the Run screen:
c
d
Item
Description
c
Primary (left side) implement height indicator
d
Secondary (right side) implement height indicator
These operate in the same way as the single receiver FieldLevel height indicators. See Blade
position indicators, page 196.
Auto buttons
With a tandem/dual configuration, the Autopilot Engage button is replaced with two
FieldLevel Auto buttons:
2 20
•
With a tandem configuration, the P:Auto button controls the
automatics of the primary ( front) implement and the S:Auto
button controls the automatics of the secondary (rear)
implement.
•
With a dual configuration, the P:Auto button controls the
automatics on the primary (left) side of the implement and the
S:Auto button controls the automatics on the secondary (right)
side of the implement.
FmX Integrated Display User Guide