Download HARTING User's Guide Transportation - HARTING

IV – Installation Instructions
IV-19 Crimping tools for D-Sub contacts 09 99 000 0501
General information:
1. Designation AFMB (M 22520/2-01) refers to basic hand tool without positioners.
Wire crimp range 20 AWG to 32 AWG.
2. The tool has a double action ratchet. Note that the tool cannot be opened without
completing the cycle.
IV
Tool preparation:
1. Tool must be in open position.
2. Remove safety clip from positioner guide.
Safety clip
3. Select positioner for contact to be
crimped.
4. Insert positioner into positioner guide and
turn 90 degrees until bayonet pins lock.
5. Install safety clip unto positioner guide
(optional).
6. Wire size and corresponding selector number are shown in data plate.
Positioner
7. With tool still in open position, raise and
guide
rotate selector knob until number indi- blue
cated on data plate for wire size to be
crimped is in line with Sel. No. arrow.
Crimping instructions
1. Insert contact and prepared wire into indenter opening from side opposite the
positioner.
2. Squeeze handles together until ratchet releases. Handle will return to the open position. Remove crimped contact and wire.
Removing Positioner
1. Remove safety clip and reverse procedure
described in step four (4) above.
Tool in open position
Tool in closed
position
Selector knob
Bayonet
pins
Positioner
“K”
series”
Data
plate
(All dimensions in Inch)
Gauge
A
B
SEL
Part No.
go Ø
no-go Ø
Nr.
G125
0.0390
0.0440
8
Table IV- 19.1
Caging limits:
Selector
No.
1
2
3
4
5
6
7
8
Caution!
Do not crimp gauge!
A ± 0.0001 B ± 0.0001
Go Ø
No-Go Ø
0.01300.0180
0.01600.0210
0.01900.0240
0.02200.0270
0.02600.0310
0.03000.0350
0.03400.0390
0.03900.0440
Green „go“
Red „no-go“
G125
(M22520/3-1)
IV-36