Download INSTALLATION & OPERATING INSTRUCTIONS

MENDOTA DESIGNER FRONTS INSTALLATION INFORMATION
The following Designer Fronts are available for the DXV-45 Fireplace:
1. Andover Arched Door Kit with Firescreen with optional Overlays as listed below:
2. Black Andover Overlay
3. Pewter Andover Overlay
4. Antique Copper Andover Overlay
5. Gold Andover Overlay
6. Prairie Rectangular Door Kit with Firescreen with optional Overlays as listed below:
7. Black Prairie Overlay
8. Pewter Prairie Overlay
9. Antique Copper Prairie Overlay
10. Gold Prairie Overlay
11. Black or Gold Victoria Filigree
12. Black or Gold Tuscany Filigree
13. Millennia Flat Grills in four optional color schemes as listed below:
14. Black Millennia Flat Grills
15. Full Brass Millennia Flat Grills
16. Classic Black and Brass Millennia Flat Grills
17. Classic Black and Bright Silver Millennia Flat Grills
Information specific to the installation of the Andover and Prairie Fronts
The Andover Door and Prairie Door Fronts are designed to be “Full-Face” trim kits. These two Fronts cover an area
equivalent to that shown in the diagram below. Any material that protrudes into this area on the sides, top or bottom edges can only be flush with the front surface of the fireplace faceplate.
If planning to install either the Andover
Door or the Prairie Door Front, DO NOT
COVER THE FACEPLATE OF THE
FIREPLACE WITH ANY MATERIALS.
Furthermore, any drywall or wall covering material that is adjacent to the sides,
top or bottom of the Fireplace’s faceplate may not protrude out past the front
surface of the Fireplace Faceplate’s
front surface.
The Andover and Prairie Doors Mounting Faceplate (required for installation of
the Andover and prairie Doors) may be
covered over with noncombustible facing
materials.
To install Tile, Marble, Slate, Stone,
Rocks or other noncombustible to enhance the arch shape of the Andover
Doors or the Rectangular shape of the
Prairie Doors, do so only after the Andover or Prairie Door Kits have been installed on the DXV-45 Fireplace.
21