Download INSTALLATION & OPERATING INSTRUCTIONS

Transcript
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING
Do not operate this appliance with the glass removed, cracked or broken. A licensed or qualified person should do replacement of glass.
Attention. Ne pas utiliser l’appareil si le panneau
frontal en verre n’est pas enplace, est craqué ou
brisé. Confiez leremplacement du panneau à
untechnicien agréé.
This appliance must be installed in accordance
with local codes, if any; if none, follow the National Fuel Gas Code, ANSI Z223.1, or Canadian
Installation Codes, CAN/CGA-B149. Gas and
Propane Installation Code, CSA B149.1
Installer l'appareil selon les codes ou règlements
locaux, ou, en l'absence dételés règlements, selon les codes d'installation ANSI Z223.1, National
Fuel Gas Code ou CAN/CGA-B149 en vigueur.
This appliance is only for use with the type(s) of
gas indicated on the rating plate and may be installed in an aftermarket, permanently located,
manufactured home (USA only) or mobile home,
where not prohibited by local codes. See owner's
manual for details.
Cet appareil doit être utilisé uniquement avec le
type de gaz indiqué sur la plaque signalétique.
Cet appareil peut être installé dans une maison
préfabriquée ou mobile (É.-U. seulement) installée à demeure si les règlements locaux le permettent. Voir la notice de l'utilisateur pour plus de
renseignements.
Caution: Label all wires prior to disconnection
when servicing controls. Wiring errors can cause
improper and dangerous operation.
In the Commonwealth of Massachusetts:
• Installation must be performed by a licensed
plumber or gas fitter;
• A CO detector shall be installed in the room
where the appliance is installed.
CAUTION
THESE INSTRUCTIONS ARE TO REMAIN
WITH THE HOMEOWNER.
1
Attention. Au moment de l’entretiennes commandes, étiquetez tous les fil savant de les débrancher. Des erreurs decâblage peuvent
entraîner unfonctionnement inadéquat
etdangereux.