Download ChlorMaker DO TM OPERATING INSTRUCTIONS

BOOST MODE
Boost Mode is designed to replenish chlorine that was just used during the last spa use. Activating Boost Mode
will take ChlorMaker DO out of regular production mode or standby mode and re-start the production of chlorine
according to the following table. To activate Boost Mode simply press the Boost Mode Button. The Salt Light will
begin flashing indicating that ChlorMaker DO is engaged in Boost Mode.
Power
Level
1
2
3
4
5
6
7
8
9
10
Normal Time
(Minutes)
2
7.5
15
30
45
60
90
120
150
180
Boost Mode Time
(Minutes)
8
30
60
120
180
180
180
180
180
180
TROUBLE SHOOTING
It is always a good idea to revisit the user manual to make sure installation or maintenance steps were not overlooked before referring to the trouble shooting section.
Problem
Consistently Low
Chlorine
Possible Causes
Corrective Action
Power level too low
Increase the power level
Plates need cleaning
Soak the unit in Vinegar for 30 minutes
Low salt level
Adjust the salt level as necessary - use test strips
Large bather load
Additional chlorine or shock may be needed
Just doesn’t keep up
Remove organic material, such as leaves, etc.
Clean the filter
Remove Phosphates
Shock the water
Consistently High
Chlorine
Power level too high
Lower the power level
No Chlorine (Solid
RED & GREEN
Lights)
Salt level may be too high Dilute the spa water by draining some of the spa water and
and engaged the automat- refilling with fresh water.
ic shut down feature.
Plates Are Dirty
With White Or
Scale Build Up
Hard water, high calcium
and minerals in water.
Soak the cell in vinegar or diluted acid for 30 minutes. Reduce calcium level in water.