Download Polygon User Manual
Transcript
All the links mentioned in the previous sections are inserted at the current cursor position. This strategy is not good enough if you want the link to bring the text view to a different cursor position. The way to do this is by using the text link toolbar button which can be found on the tool bar between the “global link” button and the “presentation” button and it has this symbol: . 1. Place the cursor at the point in the text file to which you want the hyperlink to move the cursor. 2. Press the text hyperlink button. This will create the hyperlink, but not yet insert it in the text. The button will look like it’s pressed, indicating that a hyperlink has been created. 3. Move to the text pane and position where you want the actual hyperlink to be inserted. 4. Press the text hyperlink button again, and the link will be inserted there. 3.1.4 Link Error Reporting Most hyperlinks in Polygon will reference data that you have imported. For example, a graph may refer to the “LKneeAngle” and “RKneeAngle” data objects from an imported C3D file. Some times the link may not be able to locate these data variables. In earlier versions of Polygon, this used to cause an error message and a link failure. This has, from build 072, been replaced by an error reporting mechanism. The link will still work, but if the data cannot be found you will not see what you’d expect to see in the resultant view. Sometimes this doesn’t matter at all. For example, if a link was created to a workspace view containing a skeleton and three force plates and this was used to create a template. If, at a later stage, this template is used to create a report based on a data file which has only got two force plates in it, the link will still work - but you’ll see only two force plates, of course. If Polygon fails to locate data, it will provide you with an error message which you may or may not choose to have a look at. The message is available by clicking on tool bar button number 5 ( ). However, if you clicked a link and everything went smoothly, this button will be greyed out, indicating that the link located all the data without problems. 3.2 Presentation Mode Polygon has the ability to create a presentation. This means that you can set up hyperlinks not in the text, but in a list that can be used sequentially. To start the presentation mode, press the toolbar icon that is meant to look like an overhead projector (number 21, ). The toolbar button will stay down, indicating that you’re now in presentation mode. Any hyperlink you create now will not appear in the text view. You can create hyperlinks to any configuration of views, also to configurations without text views. The links you create in presentation mode will go into a presentation list sequentially. Once you have finished creating the list of hyperlinks, you can start the presentation by going to the start of the list and pressing the hyperlink backwards/forwards button ( and ) to navigate through it. To start at an arbitrary point in the list, or to edit it, go to the “Edit” menu and choose the “Presentation” item. This will only be available when you are in presentation mode, so make sure that you have pressed the toolbar button first! Medical Software Last edited by Lasse Roren on 07/02/02 Page 22 of 51