1
Download Troubleshooting Guide
Transcript
1 TROUBLESHOOTING FOR THE HARDWARE Paper misfeed in the Finisher and the Hole Punch Unit (both optional) 1 Separate the Finisher from the equipment. 1) Open the front cover of the finisher when the Hole Punch Unit is not installed. Open the Hole Punch Unit cover when the Hole Punch Unit is installed. 2) Pull the lever to unlock the finisher. When the Hole Punch Unit is not installed When the Hole Punch Unit is installed 2 1 2 1 3) Placing your hands on the positions shown in the figure, move the finisher slowly until it stops, and then open the front cover of the finisher. When the Hole Punch Unit is not installed 26 When the Hole Punch Unit is installed 2 Raise the lever and open the upper receiving tray of the finisher. 3 Remove the misfed paper. Clearing a Paper Misfeed
