Download Troubleshooting Guide

1 TROUBLESHOOTING FOR THE HARDWARE
1.TROUBLESHOOTING FOR THE HARDWARE
„ Clearing paper misfeeds caused by a wrong paper type setting
Paper misfeeds occur when there is a mismatch between the type of paper in a drawer and the one registered for the
drawer in the equipment. “Check paper type setting for drawer N” appears on the touch panel.
In this case, just clearing the misfed paper does not prevent another paper from being misfed. Be sure to follow the
procedure below.
Troubleshooting differs depending on how the paper misfeed has occurred:
P.41 “Misfeed when making copies or prints”
P.43 “Misfeed when printing from the FAX”
‰ Misfeed when making copies or prints
1
Clear the paper misfeed following the guidance shown on the touch panel.
2
Open the paper source drawer, check that the guide
width is correct and there is no folded/curled paper or
overloading, and then close the drawer.
Be sure that the height of the stacked paper does not exceed the
line indicated inside of the side guides.
3
Close all the drawers or covers.
Clearing a Paper Misfeed
41