Download 744T User Guide and Technical Documentation

Transcript
Headphone Output
• analog tape out, 3.5 mm TRS, two-channel
• digital 1, AES3id, BNC connection, two-channel
Analog Line Out L, R
The analog line outputs are active-balanced line-level signals on Switchcraft TA3M locking connectors. The output level is a nominally 0 dBu at −20 dBFS. The level of the line output can be attenuated in the setup menu by up to 40 dB in 1 dB increments.
Analog Tape Output
The tape output connection is stereo, unbalanced consumer output level (–10 dBV) on a TRS 3.5 mm
connector. Output attenuation does not affect this output level.
Digital AES3id Output
The unbalanced AES3id output is directly compatible with most S/PDIF inputs. Attenuation to the
Master Output Bus affects both analog and digital signals.
Output Bus 2
Just as with the Master Output Bus, Output Bus 2 can be assigned signal sources from inputs or
tracks. Sources assigned to Output Bus 2 are exclusive and do not affect the assignments to the Master Output Bus or headphone assignments. The same signal sources available for the Master Output
Bus are available for Output Bus 2 (see chart above).
Digital AES3id Output 2
Output Bus 2 appears solely on the AES3id BNC output connector. There is no analog output connections for Output Bus 2. The unbalanced AES3id output is directly compatible with most S/PDIF
inputs. The maximum output level is 0 dBFS and can be attenuated in the setup menu in 1 dB increments by 40 dB.
Headphone Output
The 744T headphone output is a flexible tool for monitoring audio in the field. The 744T allows the
user to monitor inputs, tracks, or post-record tracks. The headphone output is independent of the
Master Output Bus and Output Bus 2—audio sources can be routed to headphones independent of
routing assignments to output buses.
The 744T is capable of driving headphones to extremely high sound pressure levels. Hearing experts
advise against exposure to high sound pressure levels for extended periods.
Choosing Headphone Sources
The headphone source display on the main LCD screen (
) shows the audio sources sent
to headphones. The 744T comes from the factory with 10 preset headphone audio source selections
available on the Multi Function Controller. These selections include inputs, tracks and track monitors. Turn the Multi-Function Controller on the right panel when at the main LCD screen to select
among the available headphone monitoring sources.
Track Monitor
The 744T can monitor recorded audio from the internal hard drive or Compact Flash while recording. To monitor recorded tracks, select one of the track modes with an “m” following the track
designations. Because of the record buffering of the 744T, a delay of up to 12 seconds can be expected
before recorded audio appears at the output. The 744T will play back recorded audio from the media
highlighted on the LCD panel (see File Management and Copying for more information on selecting
and highlighting recording medium).
19