Download 744T User Guide and Technical Documentation
Transcript
Recording and Playback While recording, the power, ff, rew, input, tone, and drive keys are disabled. Stop recording by pressing and holding the STOP key. The Stop key must be held for 150 ms or greater to end recording. Although you can enter the setup menu during recording, menu items that will affect recording are lined out in the menu list. When using the recorded track monitor selection, there is a sample rate dependent delay in the signal. At 48 kHz sampling, the delay is approximately 12 seconds. This delay is due to the record buffering topology. Audio can not be monitored until it has left the record buffer and written to the recording media. During recording, subsequent presses of the record key can perform one of three setup-menu-selected actions: • no action, • new cue - cue markers are set within the file being written, • new file - a new file is started with each press of the record key, the take counter is increased by one. When removing the CF from the 744T, always observe the amber activity LED for the CF medium. If it is lit, wait until it goes out before removing the CF. If you remove the CF while the LED is lit, the file will be corrupted and there is a possibility of FAT corruption as well. Playback Press play to begin file playback. The 744T has high-resolution playback circuitry and is appropriate for any reference audio application. Any file recorded by the 744T can be played back, including MP3 file playback. In addition, files copied to the storage mediums from a computer can be played back. This is useful when using the 744T as a high-resolution playback device. The 744T plays back the last recorded audio file unless another file is selected. There are two ways to select another file for playback. To select another file in the current record directory, push either the FastForward or reverse key to put the 744T in to play-stop mode. The filename display will begin flashing and the FastForward and Reverse keys are used to step through files available in the current record directory. To select a file in an alternate directory, press the HDD key to enter the media directories. Navigate to the appropriate directory. Select the file that to play back with the Multi-Function Controller and press play. If the stop key is pressed while playing files from an alternate directory, the 744T will revert to the current daily directory. AutoPlay The 744T can be set to play back all valid audio files in a directory. Files will play back in their order in the directory. Autoplay can be set with the following options: • • • • Disabled – auto playback is off Play all – all files in the directory will play, then stop when all files have been played Repeat one – the selected file will play back continuously until stopped by the user Repeat all – all files in the directory will play in succession, then repeat until stopped by the user 31