Download Gemstone User Manual
Transcript
FlashTool 6.2.2 Install SAM-BA Windows Driver If the distribution package AT91-ISP 1.1X from Atmel already is installed on your computer, you don’t need to install the custom FlashTool driver from Proelec if the version of the package is 1.10 or higher. If you have an older version you must uninstall the AT91-ISP 1.1X package before installing the driver from Proelec. If you want to install the FlashTool driver from Proelec, just go to the Tools menu in the program and select install driver, See figure 6.2. The driver is not Microsoft certified, so you must accept the installation when the acceptance dialog appears on the screen. When installation of the driver is finished the board can be started up in SAM-BA (programming) mode, see 6.2.3. Figure 6.2 6.2.3 Starting up the board in SAM-BA Mode Hold down button U6 (see figure 2.1) while switching on the board power supply (5V). If you hear a sound from the PC, the board should be in SAM-BA (programming) mode. If you have problems to set the board in programming mode, check that the device exists in the Windows device manager. If you have installed the Proelec driver you should look in the Ports (COM and LPT) category of devices, and if you have installed the AT91-ISP 1.1X package you should look in USB devices. GEMSTONE User Manual 45 www.proelec.se