Download GTR-600 User manual

A. Genset Info.: Display generator inforamtion
B. Event Record: Display operation history
C. Parameter Modify:
1. Crank Settings
1. Detect Frequency
Setting：Disable/ Enable
Default：Enable
Description：Check frequency value before cranking the engine.
2. Detect oil press
Setting：Disable/ Enable
Default：Enable
Description：Check oil pressure before cranking the engine.
3. Crank interval
Setting：5~40(seconds)
Default：10
Description：Set the duration of each crank.
4. Crank attempts
Setting：1~10
Default：3
Description：Set total number of crank attempts.
5. Escape up limit
Setting：15~30(Hz)
Default：20
Description：When frequency reaches setting, starter motor disconnects from engine.
6. Engage low limit
Setting：15~30(Hz)
Default：20
Description：If frequency is below setting allows crank procedure
7. OP build up time
Setting：0.2~2.0(Seconds)
Default：0.6
Description：Time delay before disconnecting starter motor after oil pressure switch activates.
(“Detect oil press” must be enabled.)
8. Idle interval
Setting：0~600(Seconds)
Default：0
[9]