Download Installation Manual

X4 Network/Fieldbus
1.6.1
Selection of Network protocols
Display and Controls
The DIL switch is not supported here.
Adjust via [Setup]-[Network Parameter].
Caution!
Make sure that the switches 1…8 are set to position ‘OFF’ before and after installation!
Flashing 1 Hz green
Flashing 2 Hz green
Flashing 1 Hz red
Flashing 2 Hz red
Flashing 4 Hz red
Watchdog LED
Module initialized and running without problems.
Module not initialized.
RAM check error
ASIC and FLASH ROM check error
Ethernet-RAM check error
Front panel display: [Setup]-[IO-Slots]
or mounting plate (rear panel):
LED 1
Off
Lighted green
Connection (Link)
Flashing 1 Hz green
Lighted red
Flashing 1 Hz red
Flashing 2 Hz red
Flashing 4 Hz red
LED 2
LED 3
LED 4
IP- address not
supported*
Bi-directional package
traffic busy
Number of units
detected on the
ModBus
IP-address double
Invalid MAC address
[Ethernet config]
loading error
internal error (Fatal)
* No errors possible, DIL switch setting is not supported for PR5510.
Sartorius
EN-29