Download User's Manual

Transcript
Uroflow System
Setup and Use Quick Reference
Note: To turn on the ScanPoint Remote when it is in sleep mode, press and release the Remote button.
®
Remove the FloSensor from the FloCharger
Wearing gloves and using the handles, remove the FloSensor
from the FloCharger. Spread the handles and place the
FloSensor in the toilet bowl as shown.
The FloSensor will beep and the motor will start spinning. It
will take approximately 45 seconds for the FloSensor to
warm up.
Place the Funnel on the FloSensor
Press the tabs around the FloSensor handles to secure the
Funnel in place.
To start the exam, press and release the
button on the ScanPoint Remote
®
Position the Remote within 10 feet of the FloSensor; press and
release the button on the ScanPoint® Remote to start the exam
process. When you hear a chirp from the Remote, see a “0” on
the Remote, and hear beeps from the FloSensor, the device is
ready to perform an exam.
Press and
Release
Instruct the patient
Tell the patient that the FloSensor will beep every 3
seconds to indicate normal operation. No cause for concern.
The beeping will stop when the patient begins to urinate.
Instruct the patient to relax and urinate (and only urinate)
normally into the funnel. Ask male patients to aim for the
marked location on the side of the funnel.
10 feet or less
Leave the ScanPoint® Remote within 10 feet of the FloSensor
(for example, on a hook in the restroom, or just outside the
restroom door). This distance allows the FloSensor and
ScanPoint® Remote to communicate with each other. The
Remote will provide real-time data throughout the exam.
To end the exam, press and release the
button on the ScanPoint Remote
®
When the patient is finished, pick up the ScanPoint® Remote;
press and release the button to end the exam. The ScanPoint®
Remote LCD screen displays the final volume, the peak flow
and a flashing speaker icon to indicate the device is ready for
annotation.
Press and
Release
www.verathon.com https://my.scanpoint.com
For more information, call 800.331.2313 (in the U.S. and Canada) or contact your local Verathon Medical® representative. ScanPoint®, FloPoint®, Verathon®, and Verathon
Medical® are registered trademarks of Verathon Inc. in the US and other countries. Copyright © 2007 by Verathon Inc. All rights reserved.