Download Programmable DC Power Supply User's Manual

7.6
State Bit Definition
When “ STATE?” command is used, the system will return three (3) bytes in
the order as shown below.
Byte 2
Byte 1
Byte 0
bit 7 ~ bit 0
bit 7 ~ bit 0
bit 7 ~ bit 0
The definition of each bit is described in the following table.
byte 0:
bit 7
OVP on/off status
bit 6
OCP on/off status
bit 5
OPP on/off status
bit 4
CC to CV on/off status
bit 3
CV to CC on/off status
bit 2
output on/off status
bit 1
LCD back light on/off status
bit 0
External 5V output on/off status
byte 1:
bit 7
OVP occur flag
bit 6
OCP occur flag
bit 5
OPP occur flag
bit 4
CC to CV occur flag
bit 3
CV to CC occur flag
bit 2
AC dectect low occur flag
bit 1
OTP occur flag
bit 0
reserved
byte 2:
bit 7 ~ 0
reserved
7.7
LAN Communction
All DS series provide three LAN control modes, including Web
server, Telnet and Sockets. First, enter the first Item “ System Setting”
on the menu to set the interface selection (Remote Control) as Ethernet,
and select IP setting procedure as Static or use DHCP (Dynamic Host
Configuration Protocol). If using static IP, it needs to set up IP address.
After completed, it will be able to use the above LAN control mode
to control the DS series.
75