Download USER'S MANUAL
Transcript
Chapter 2 Brown-Out Reset: The MCU is reset when the supply voltage VCC is below the Brown-out Reset threshold (VBOR). During reset, all I/O Registers are reset to their initial values, and the program starts execution from Address 0x0000. The instruction placed at Address 0x0000 must be a Long JMP instruction to the reset handling routine. If the program never enables an interrupt source, the interrupt vectors are not used, and regular program code can be placed at these locations. 2.8.1 Block Diagram Internal P ullup R esister /RESET VDD Power-On Reset Circuit (POR) Brown-Out Reset Circuit (BOR) 32K Oscillator Reset Internal Reset Control Circuit Software Reset (CPUCON register) Watch Dog Timer (WDT) Reset Reset By POR Warm-Up Timer (10-Bit) Figure 2-21 Reset System Block Diagram eSL/eSLS Series (+ eSLZ000) User’s Manual Architecture • 45