Download GX-281 Liquid Handler User's Guide
Transcript
2 Installation GX Z Injection Module Installation (Optional) GX Z Injection Module Installation (Optional) To install the GX Z Injection Module on the Z-arm: 1 Using the 5/32" Allen wrench, loosen the mounting screw on the mounting bracket located on the GX Z Injection Module. Turn counterclockwise to loosen. 2 Partially pull out the bracket. Do not remove completely. 3 Mount the GX Z Injection Module on the top left side of the Z-arm. You will need to mount one side of the injection module at a time (back to front). The valve should face the front and the mounting bracket should face the right. 4 Tighten the screw on the mounting bracket until the GX Z Injection Module is secure on the Z-arm. mounting screw mounting bracket Rear Panel—GX Z Injection Module 1 1 From Z-arm Z-arm connection Refer to the diagram and instructions that follow to make the connections from the liquid handler to the GX Z Injection Module. Before making the connections, ensure that the power is turned off to the liquid handler. 1 Plug one end of the cable supplied with the GX Z Injection Module to the FROM Z-ARM port on the rear panel of the injection module. 2 Connect the other end of the cable to the port labeled Z INJECTION VALVE on the top right side of the Z-arm. GX Z Injection Module Rear Panel 2-7