Download GX-281 Liquid Handler User's Guide

Transcript
2
Installation
GX Z Injection Module Installation (Optional)
GX Z Injection Module
Installation (Optional)
To install the GX Z Injection Module on the Z-arm:
1
Using the 5/32" Allen wrench, loosen the
mounting screw on the mounting bracket located
on the GX Z Injection Module. Turn
counterclockwise to loosen.
2
Partially pull out the bracket. Do not remove
completely.
3
Mount the GX Z Injection Module on the top left
side of the Z-arm. You will need to mount one side
of the injection module at a time (back to front).
The valve should face the front and the mounting
bracket should face the right.
4
Tighten the screw on the mounting bracket until
the GX Z Injection Module is secure on the
Z-arm.
mounting
screw
mounting
bracket
Rear Panel—GX Z Injection Module
1
1
From Z-arm
Z-arm connection
Refer to the diagram and instructions that follow to
make the connections from the liquid handler to the
GX Z Injection Module. Before making the
connections, ensure that the power is turned off to the
liquid handler.
1
Plug one end of the cable supplied with the
GX Z Injection Module to the FROM Z-ARM
port on the rear panel of the injection module.
2
Connect the other end of the cable to the port
labeled Z INJECTION VALVE on the top right
side of the Z-arm.
GX Z Injection Module
Rear Panel
2-7