Download Solution 8 Installation Manual

Transcript
Solution-8 Installation Manual
Page 25
User Codes
0...0
Locations 68 - 163
These are the 14 user codes available that can be altered at will by the master code holder. If Openings and
Closing's (locations 200 and 201) are programmed, then any code being used to arm and disarm the system, will
be transmitted to the monitoring station as the appropriate user number.
User Number
User 2
User 3
User 4
User 5
User 6
User 7
User 8
User 9
User 10
User 11
User 12
User 13
User 14
User 15
Location
68 to 73
74 to 79
80 to 85
86 to 91
92 to 97
98 to 103
104 to 109
110 to 115
116 to 121
122 to 127
128 to 133
134 to 139
140 to 145
146 to 151
Any user code starting with '00' will only arm the system. This can be helpful when you need to give a code to
someone who is only allowed to arm but not disarm the system such as a cleaner or guest.
NOTE:
If 6 digit codes are required a '1' must be programmed into location 214.
Auxiliary Codes
There are two auxiliary codes which are capable of triggering any two of the four programmable outputs. As an
example these codes could be used to unlock a door to allow access into a secured area. Outputs can only be
triggered from these codes while the system is in the disarmed state. An appropriate output will have to be
programmed so that this function can operate. These codes can be changed from the operators programming
mode (Master code + 1) as they are treated as user codes 16 and 17 respectively. These codes do not arm or
disarm the system. Their only function is to operate the programmable outputs.
Auxiliary Code
Aux code 1
Aux code 2
Location
152 to 157
158 to 163
Electronics Design & Manufacturing
ISSUE401.DOC