Download Solution 862 Installation Manual

62
Solution 862
Installation Manual
<"74(0"(,-"#.%4(
The method of code to isolate restricts only those user codes that have the priority level Code
To Isolate set to be able to isolate zones. Therefore, if any user code has this priority level set,
the method of standard isolating will be disabled.
1.
Press the
2.
Enter your
3.
Press the
button.
Three beeps will be heard and the STAY indicator will begin to flash. If you attempt to
enter isolating mode with a user code that has not been allocated for code to isolate, the
system will ignore the attempt to enter the mode.
4.
required to be isolated followed by the
* Enter the
zone you have just selected to be isolated will now begin to flash.
button.
.
button. The
24 hour zones will automatically isolate as soon as the
button has been pressed.
All other burglary zones will automatically isolate only after the system has been
armed.
Repeat Step 4 if more than one zone is required to be isolated until all zones that are
required to be isolated have been selected.
5.
Press the
button when finished selecting the zones to be isolated.
Two beeps will be heard and the system will return to the disarmed state.
The zones selected to be isolated when you arm the system in AWAY Mode, STAY Mode 1 or
STAY Mode 2 will continue to flash until the system has next been disarmed.
+
+
+
*
+
+
As each zone is selected to be isolated, the corresponding ZONE indicator will begin
to flash. If a mistake is made, press the zone number that was incorrectly entered
followed by the
button. This zone is now no longer selected to be isolated and
the ZONE indicator will extinguish.
89-7:;,!
If you wish to manually isolate zones 1, 3 and 4, the following sequence would be entered
below;
+
+1+
ISSUE130
+3+
+
+4+
Electronics Design and Manufacturing Pty Limited
+