Download SN User Manual

Transcript
Diagnostics Screens
Total Flashes
The FTC 121-1 Controller provides internal monitoring
of system operation. Because it does this, it can communicate the operating parameters by telephone or by using
the screen to service personnel for diagnosis and repair.
The Diagnostic screens are intended for service personnel.
T3B4
Actual:
Missed:
121,123
1
Figure 5-4 Total Flashes Screen
Button Functions:
Diagnostics Selection
•
The ENTER Button moves the cursor from the beginning of the top line to the tier and beacon number.
From there the UP and DOWN Buttons cycle up or
down through the installed beacons and show the
count for each beacon position.
•
•
•
The DOWN Button moves to the next screen.
You select the Diagnostic Screens by moving the cursor
to the Diagnostics line on the User Menu and pressing the
ENTER Button.
The following sections discuss each Diagnostic Screen in
the order of their appearance.
Total Flashes Screen
The example screen shows the total flash count of day,
twilight, and night mode flashes (since installation) for
the third tier fourth beacon. See Section Diagnostics on
Page 5-3 for an explanation of the screen items.
The UP Button moves to the previous screen.
The EXIT Button displays the User Menu with the
cursor at the Diagnostics line.
Day Flashes Screen
The example screen shows the total day mode flash count
(since installation) for the third tier fourth beacon. See
Section Diagnostics on Page 5-3 for an explanation of the
screen items.
Day Flashes
Actual:
Missed:
T3B4
60,000
1
Figure 5-5 Day Flashes Screen
Button Functions:
FTC 121-2
•
The ENTER Button moves the cursor from the beginning of the top line to the tier and beacon number.
From there the UP and DOWN Buttons cycle up or
down through the installed beacons and show the
count for each beacon position.
•
•
•
The DOWN Button moves to the next screen.
The UP Button moves to the previous screen.
The EXIT Button displays the User Menu with the
cursor at the Diagnostics line.
Revision 2 — 6-24-2003
5-5