Download User Manual

Transcript
21
Wiring Diagram Example
No.
Input
Connection Type
1
Master Valve
The Master Valve is the primary valve in the system. It is advisable to install a master valve as
it will provide extra insurance in the event the other valves fail. The master valve input can be
configured to operate a pump.
2
Flow Sensor
It is recommended to install a flow sensor after the Master Valve but before the other
solenoids in the irrigation system. This will allow the flow sensor to monitor the amount of
water flow during each watering cycle for each water outlet. A flow sensor can be used
to detect any potential leaks in the irrigation system by monitoring water flow. WaterMe
includes a 1” Flow Sensor.
3
Solenoids Valves
One solenoid valve is required to control the watering of one zone. The number of zones
required will depend on a number of variables such as input pressure and flow, each
sprinkler consumption, and watering requirement for individual plants.
Flow Sensor Connection
DC24 MOIS VPP RAIN FLW2 FLW3
DC24 GND GND FLW1 GND GND
!
•
MV
Wire Colour
Sensor Terminal Input
Red
VPP
Yellow
V1
Black
V2
V3
FLW1
V4
V5
Common/Ground
V6
V7
COM
Note
The installation provided should be used as an example only. Actual installation configuration may vary based
on individual situation
V8
V9
V10