Download User Manual

22
SECTION 6.4
Connecting Wires to the Terminals
Please ensure you follow the correct procedure in connecting the valve and sensor wires to WaterMe. The controller has
provisions for up to three flow sensor (one included), moisture sensor, rain sensor, a master valve and up to ten solenoid
valves.
To connect the valve and sensor wires you will need the following;
No.
Name
1
WaterMe Wireless Irrigation Controller
2
Valve Wires
3
Sensor Wires
4
Ethernet Cable (only required if hard wiring the connection)
5
Mains power supply (ensure the power source is within 1.5 metres (5 feet) of the controller
6
Flathead screw driver (not supplied)
!
•
Ensure that the zones wires and sensor wires are in the correct inputs. Incorrect placement will result in
a non working system and may result in potential damage to your WaterMe controller. The inputs to the
controller do have short circuit protection but care during installation is required.
i
•
1.
2.
Note
Information
If your irrigation project requires more than 10 zones it is possible to purchase multiple WaterMe devices
and create one user account.
Insert the wires through the conduit where you have
made the incision.
Locate the wire entry points you will be using. Using
the flat head screw driver, turn anti-clockwise to fully
open the terminal housing.
3.
Insert the wire into the terminal and retighten turning
the screw driver clockwise. Ensure that you do not
overtighten as it may cause damage to the controller.
3
2