Download FlexDrive Installation Manual

Drift
If you know the input offset value of the control, you may enter the value manually.
Otherwise, you may initiate automatic offset tuning and let the control measure
and set this value. Click “Download” when finished.
Figure A-8 Drift Parameter Screen
Manual Tuning The first six steps of the manual tuning process is shown in Figure A-9.
Figure A-9 Select Manual Tuning
4
1
Select
Tuning
5
Select Pole
Placement
Enter either Inertia
or Inertia Ratio
(the other value is
automatically
entered).
2
Select Manual
Tuning
3
Select OK
6
Enter a value
for Bandwidth
7
Click on
Download
If “Pole Placement” method of adjustment is selected, you would enter values for
“inertia” or “inertia ratio”. Enter either one, and the other value will automatically
be entered. This is the easiest and recommended method of adjustment.
If “PI” method of adjustment is selected, you would enter values for GV--gain and
GVI--gain. This is an advanced method of adjustment, and is more difficult.
Both methods of adjustment provide identical results. PI method is described
later in this section.
MN1275
Manual Tuning A-5