Download AC Variable Speed Drive Installation & Operating Instructions

Optidrive ODP-2 User Guide Revision 1.00
Optidrive P2 Easy Start Up Guide
AC Supply Connection
3 Phase Units : Connect L1 L2 L3, PE
1 Phase Units : Connect L1, L2, PE
Fuses or MCB
Supply Voltage
200 – 240 Volts + / - 10%
380 – 380 Volts + / - 10%
Fuses or MCB
o Check the Drive Rating Information on page 33
Help Card
Display
Keypad Operation can be found on page14
Control Terminals
Based on the factory default parameter settings
Safe Torque Off (STO)
Run – Stop
10K Speed Pot
Link the terminals as show, Close the switch to
through the emergency stop run (enable), open
circuit contacts
to stop
Motor Cable
o For correct cable size, see Technical Data on page 33
o Observe the maximum permissible motor cable length
o For Motor cable lengths > 50 metres, an output filter is
recommended
o Use a screened (shielded cable)
M
2
Motor Connection
Check for Star or Delta Connection
Enter the Motor Nameplate Data into the drive Parameters as follows
o Motor Rated Voltage : P1-07
o Motor Rated Current : P1-08
o Motor Rated Frequency : P1-09
o Motor Rated Speed (Optional) : P1-10
www.invertek.co.uk