Download User Manual Interroll RollerDrive

RollerDrive EC300
Assembly
Inserting the RollerDrive EC300 in the conveyor frame
Inserting the motor shaft
¾ Remove the shipping tube from the RollerDrive/harness assembly.
Hint
Use caution when cutting the tie-wrap from the harness. Do not cut any of the
sleeving or wires on the assembly.
¾ Place a first star washer on the motor shaft.
¾ Pass the motor cable through the 11 mm (0.44 in) hex hole in the conveyor
frame and insert the motor shaft into the hex hole.
Internal damage of the RollerDrive due to improper
handling
¾ Do not install the securing hardware at this time.
¾ Do not bend the motor cable at the motor shaft. Leave
a minimum of 12 mm (0.5 in) of excess cable for stress
relief.
¾ Place one or two standard 4 mm, max. 5 mm (3/16 in) O-rings or RollerDrive
belts (if used) on the idler end of the RollerDrive.
Version 1.0 (11/2007) en
Original language
19