Download Mech-Q

Transcript
The editing utility asks you to pick the 3D shaft to edit. Once selected, the
shaft data is displayed in a list format (in the same order as the data was
entered when the shaft was first drawn). By selecting any item on the list,
the utility brings up an edit dialogue to edit the selected shaft detail. When
editing shaft data you must make sure to have the last two diameter sizes
equal (this is a signal to the program interpreter that the last diameter is a
terminating diameter).
Select the OK tab when finished editing.
Select the "Exit" tab in the main dialogue to end the utility.
Chamfer – External
Toolbar menu:
Drop-down menu:
Mechanical
Mechanical– Chamfers
Shft Chmf.
This is a utility for drawing a chamfer to an existing shaft/pinion.
You are only required to pick the shaft end entity and then input the
chamfer length (longitudinally) and angle. The utility draws the chamfer
and trim lines as required.
Chamfer – Internal
Toolbar menu:
Drop-down menu:
Mechanical
Mechanical–Chamfers
Hole Chamfer
This is a complimentary utility in addition to the external chamfer utility
(above).
You are required to pick the intersecting point that defines the hole start,
input the chamfer length (longitudinally) and chamfer angle.
The chamfer is then drawn and lines trimmed accordingly.
Spur Gears
Toolbar menu:
Drop-down menu:
Mechanical
Mechanical–Spur Gear
This utility is used to draw Spur Gears.
45