Download User's Manual

Transcript
1.4.
Working principle
The KD9 controller may be freely configured by the menu. The hardware contains three boards. Take in account that
the well-chosen set of boards could fulfil the requirements. You ought to study the MANUAL and the relay
arrangement before ordering.
The lower board is the base of the controller, without this it does not work. The upper and middle boards can be
chosen uniquely each and together. The ordering code can be seen in the table underneath.
KD9-
Universal controller with 10000 programsegment
0 0 0 0 0 0 0 0 0 0 Base construction with 1 input + 2 relays,
1
lower
panel
6 inputs
3 relays (2 Form C + 1 Form A)
5 relays (5 Form A)
3 Ssd (OPC 12 V/10 mA)
5 Ssd (OPC 12 V/10 mA)
1
2
3
4
1
2
3
4
upper
panel
+3 relays (3 Form C)
+6 relays (6 Form A)
+3 Ssd (OPC 12 V/10 mA)
+6 Ssd (OPC 12 V/10 mA)
Loop Power Supply (isolated) (24 Vdc, 100 mA)
0/4-20 mA 2. isolated analogue output (max. 600 ohm)
0/1-5 V
2. isolated analogue output
0/2-10 V
2. isolated analogue output
0/4-20 mA 1. isolated analogue output (max. 600 ohm)
0/1-5 V
1. isolated analogue output
0/2-10 V
1. isolated analogue output
RS232 not isolated
RS485 isolated
ETHERNET on MODBUS
1
3
4
5
3
4
5
1
2
3
1
2
3
middle
panel
7 digital inputs
7 digital inputs + adapter (not isolated)
7 digital inputs + adapter (optically isolated)
1
„Centronics” interface for ESC/P and CBM-920 type printers
3
0/4-20 mA 3.,4. analogue outputs not isolated (max. 250 ohm)
4
0/1-5 V
3.,4. analogue outputs not isolated
5
0/2-10 V
3.,4. analogue outputs not isolated
1 MMC inner interface
2 MMC inner interface + panel mountable adapter
There are short specifications for software and hardware properties in the table. You can find properties by the codes.
The software determines the relationship among the inputs and outputs. Therefore you can use these options which
you have bought.
The tree-structured menu is user friendly. Some parameters are not displayed, depending on the protect mode
setting, the option boards used or the enabled-disabled status. So, e.g. if you configure an RTD the parameters of
cold-junction will not appear in the menu.
Instead of the complicated control structure it has a very simple configuration method which will be shown in the the
CONFIGURATION NAVIGATION DIAGRAM.
You can configure the controller by keys placed on the front panel (bezel) or from a PC. The front panel display shows
all the information you need in the configuration process.
The KD9 can accept the messages from outer instruments ad can send too by the digital inputs and outputs. You can
set up control net through the communication ports among two or more controllers. On one RS485 line you can
connect 31 slave and 1 master controller together. The PC can accept so many groups as the number its serial
(RS232) ports.
The built in printer interface operates the matrix printer through parallel cable.
4