Download User's Manual
Transcript
1.4. Working principle The KD9 controller may be freely configured by the menu. The hardware contains three boards. Take in account that the well-chosen set of boards could fulfil the requirements. You ought to study the MANUAL and the relay arrangement before ordering. The lower board is the base of the controller, without this it does not work. The upper and middle boards can be chosen uniquely each and together. The ordering code can be seen in the table underneath. KD9- Universal controller with 10000 programsegment 0 0 0 0 0 0 0 0 0 0 Base construction with 1 input + 2 relays, 1 lower panel 6 inputs 3 relays (2 Form C + 1 Form A) 5 relays (5 Form A) 3 Ssd (OPC 12 V/10 mA) 5 Ssd (OPC 12 V/10 mA) 1 2 3 4 1 2 3 4 upper panel +3 relays (3 Form C) +6 relays (6 Form A) +3 Ssd (OPC 12 V/10 mA) +6 Ssd (OPC 12 V/10 mA) Loop Power Supply (isolated) (24 Vdc, 100 mA) 0/4-20 mA 2. isolated analogue output (max. 600 ohm) 0/1-5 V 2. isolated analogue output 0/2-10 V 2. isolated analogue output 0/4-20 mA 1. isolated analogue output (max. 600 ohm) 0/1-5 V 1. isolated analogue output 0/2-10 V 1. isolated analogue output RS232 not isolated RS485 isolated ETHERNET on MODBUS 1 3 4 5 3 4 5 1 2 3 1 2 3 middle panel 7 digital inputs 7 digital inputs + adapter (not isolated) 7 digital inputs + adapter (optically isolated) 1 „Centronics” interface for ESC/P and CBM-920 type printers 3 0/4-20 mA 3.,4. analogue outputs not isolated (max. 250 ohm) 4 0/1-5 V 3.,4. analogue outputs not isolated 5 0/2-10 V 3.,4. analogue outputs not isolated 1 MMC inner interface 2 MMC inner interface + panel mountable adapter There are short specifications for software and hardware properties in the table. You can find properties by the codes. The software determines the relationship among the inputs and outputs. Therefore you can use these options which you have bought. The tree-structured menu is user friendly. Some parameters are not displayed, depending on the protect mode setting, the option boards used or the enabled-disabled status. So, e.g. if you configure an RTD the parameters of cold-junction will not appear in the menu. Instead of the complicated control structure it has a very simple configuration method which will be shown in the the CONFIGURATION NAVIGATION DIAGRAM. You can configure the controller by keys placed on the front panel (bezel) or from a PC. The front panel display shows all the information you need in the configuration process. The KD9 can accept the messages from outer instruments ad can send too by the digital inputs and outputs. You can set up control net through the communication ports among two or more controllers. On one RS485 line you can connect 31 slave and 1 master controller together. The PC can accept so many groups as the number its serial (RS232) ports. The built in printer interface operates the matrix printer through parallel cable. 4