Download User's Guide - Finn-ID

2. Click the Execute button. The Output tab appears displaying the network routing table.
3. This table displays Destination, Netmask, Gateway, Metric, and Interface columns. Scroll right to see all the columns.
To Add a Route
You can add a custom route with the Add command.
1. On the Input tab, select ADD in the Command drop-down list. Fields appear on the Input tab.
2. Specify the range of IP address to which this rule will apply using the Destination and Netmask fields. For example, the
settings in the screenshot below specify an address range from 300.300.0.1 to 300.300.255.254.
3. Enter the Gateway.
4. Enter the Metric (not required).
5. Enter the Interface (not required).
6. Tap Execute. The system verifies your results and the Output tab lets you know if your entry was added successfully.
Dolphin® Power Tools™ User’s Guide
Rev D
2/23/07
8-7