Download Manual

Dec
Hex
52
0x34
Auto Test Period
53
0x35
Auto Test Mode
54
0x36
Low Sensitivity
55
0x37
Target Acquisition Quality
62
0x3E
Target Loss Quality
64
0x40
TX On Time
65
0x41
TX Off Time
76
0x4C
Enhanced Test
79
0x4F
Get Product Type
81
0x51
Get Software Version
Traffic
232
Appendix C Ref
Speedometer
232 & 485
Setting Description
Stationary
232 & 485
Setting ID
Available Values
Default Setting
10 – Testing
10 - Testing
3 – Target Recognition
3 – Target Recognition
3 – Target Recognition
9 – TX Power Save
9 – TX Power Save
10 - Testing
11 - System
11 - System
600
600
600
0
1
0
0
--
--
1 of 1
--
--
0 of 1
--
--
0
--
--
0
--
--
√
--
√
√
--
√
√
--
√
Page D-4
30-900 seconds
(can be a two byte value)
(Speedometer models fixed at 600.)
0 = Always Test
1 = Test only when radar transmitter
is on
(Speedometer models fixed at 1)
0 = Disabled
1 = Enabled
1 of 1, 1 of 10, 2 of 10, 3 of 10, 4 of
10, 5 of 10, 6 of 10, 7 of 10, 8 of 10,
9 of 10, 1 of 30, 29 of 30 (or any
combination of x and y where target
acquisition requires >= x of the last y
buffers to have good signal to noise;
y must be in range 1-32; x must be
<= y)
(can be a two byte value)
0 of 1, 1 of 10, 2 of 10, 3 of 10, 4 of
10, 5 of 10, 6 of 10, 7 of 10, 8 of 10,
9 of 10, 1 of 30, 29 of 30 (or any
combination of n and m where target
loss requires > n of the last m
buffers to have bad signal to noise;
m must be in range 1-32; n must be
< m)
(can be a two byte value)
Range for both is 0-60000 ms (0-60
sec) (can be a two byte value).
These values provide a transmit
on/transmit off duty cycle. If either is
= 0, there is no duty cycle, and the
transmitter is controlled by setting 42
only.
0 = Get last test result
1 = Initiate test and return result
1 = Request the return of a three
byte code associated with the
product model (read only)
1 = Request the return of an ASCII
string containing the software
version (read only)