Download CP-System User's guide

Introduction: About CAD-Profi programs
Introduction
About CAD-Profi programs
CAD-Profi software consists of programs „CP-Manufacturers”, „CP-Symbols”
and „CP-System”.
•
CP-Manufacturers – the program is a kind of electronic catalogues
that contain libraries of blocks of known manufacturers. It is distributed
by manufacturers of devices. „CP-Manufacturers” is included in „CPSystem” program.
•
CP-Symbols – it is a program containing complete libraries of symbols for various branches as well as basic commands supporting schemas edition. Available modules: “HVAC”, „Electrics” „Mechanics” and
“Architecture”.
•
CP-System – a comprehensive application that supports computer
designing of installations. There are available two basic modules:
“HVAC” and “Electrics”, in which a designer can create any schemas, plans and sections. The following modules are also available:
„Architecture” – it contains elements that support creating of architectural projects,
„Mechanics” – it contains an extensive set of standardized elements
used in mechanical and structural projects.
CAD-Profi programs can work as applications for various CAD programs. It
means that CAD program is understood as AutoCAD or IntelliCAD program
in this manual. Many commands in these programs work similarly. If there
are any differences, it is described in details.
CAD-Profi Programs can cooperate with the following CAD programs:
•
•
•
AutoCAD from 2000 version
AutoCAD LT from 2000* version
Most IntelliCAD distributions from 4.0 version.
*) in AutoCAD LT, there is necessary to install additionally LTX™ or LT-Extender program
4
JL Systems Group
Slottsmollan
302 31 Halmstad
Sverige
Tel: +46 35 7777030
www.jl-systems.dk