Download Installation Manual
Transcript
Attaching the propulsion unit Installation Manual Figure 29. Attaching the hydraulic pump 2. Fit the belt in place. 3. Lift the rack by cranking it from point C indicated in figure 29. 4. Tighten the screws. The tightening torque is 46Nm. 5. Install the pressure hose to connectors D and E (figure 29). 6. Install the reservoir hose to connector F (figure 29). 7. Install the oil reservoir and its rack to a suitable place above the pump. Figure 30. Oil reservoir and rack AM/245/EN/1.1.0 29