Download Operating instructions

Flat and curved conveyor AM-F / AM-C
Content
Pos: 6.56 /KN2006-Projekte/Geppert/Installation & Inbetriebnahme/Förderkette_einstellen @ 29\mod_1170423490151_2.doc @ 336065
Adjusting the conveyor belt
The conveyor belt has already been adjusted to the required sag
by the manufacturer. If necessary, re-adjust as follows:
Fig. 26:
1.
Loosen bolts (1) on either side of the return roller holder (2)
with an Allen key (5 mm).
2.
Slide the reverse roller holder and adjust the required sag of
the conveyor belt.
3.
Tighten the bolts on either side of the return roller holder.
Fig. 26: Adjusting the sag of the conveyor
belt
ATTENTION!
The sag of the belt must be more than 20 mm
below the drive roller. In general: The longer the
conveyor belt, the greater the sag. A re-adjustment
may be necessary if the temperature changes.
Pos: 6.57 /KN2006-SM/nL.......... Seitenumbruch .......... @ 8\mod_1141998334703_0.doc @ 75491
09/2009
43