Download Operating Instructions – Explosion

Transcript
7
I
Startup
Parameter setting: Frequency inverters for category 2GD motors
0
Current monitoring
The parameters that need to be set for monitoring the current depend on the motor.
X
I1
1,5 In (Motor)
In (Motor)
Iü
Iü
C
B
A
Motor typedependent
I2
fA
fB
fC
fE
f [Hz]
4077842059
In
I1
I2
IO
Nominal current in A
permitted max. current in A
permitted continuous current range
in A
Overload current in A
X
f
A, B,
C, E
Current limitation
Frequency in Hz
limiting points
After motor startup, current limitation I1 is active. Current limitation I2 determines the current that is permanently permitted. The current limitation function can be activated during startup or via parameter P560 Current limitation Ex e motor (the Ex e motor current
limitation function is activated automatically for SEW-EURODRIVE motors of category
2 during startup).
The characteristic curve for MOVIDRIVE® is defined by operating points A, B and C. The
parameters of group P560 are preset during startup, see following table. The values are
also specified in the EC prototype test certificate.
Parameters
Maximum speed
Automatic adjustment
86
Point A
Point B
Point C
Frequency [Hz]
P561
P563
P565
Current limit in % of
IN FI
P562
P564
P566
The maximum motor speed must be limited in the "System limits" window. Observe the
following when you set the parameter maximum speed:
•
Maximum speed ≤ start of the field weakening
•
Maximum speed ≤ motor limit speed and
•
Maximum speed ≤ maximum gear unit input speed nemax (see gear unit nameplate)
The parameter automatic adjustment is activated via guided startup. Thus, the frequency inverter sets parameter IxR value with each enable signal. A manual change is
not permitted.
Operating Instructions – Explosion-Proof AC Motors EDR.71 – 225