Download INSTALLATION MANUAL - ADSF

Assemble the push arm without tightening the travel
screws A and fasten it to the automation, ensuring
it is inserted in the housing of the arm support.
Push Arm
3.3 Installation with sliding arm
Use the sliding arm for doors that open inwards (seen from
automation side).
Slide Arm Opening in
-
Fasten the bracket [B] to the door.
Remove the casing and fasten the automation on the
wall, respecting the measurements indicated in the figure: refer to the hinge axis.
Push Arm
Slide Arm Opening in
With the door closed, adjust the arm and tighten the
screws [A].
-
Bore the guide [C] and fasten it to the door.
Slide Arm Opening in
Push Arm
-
-
Insert the sliding block [D] of the sliding arm in the guide
[C]. Fasten the arm to the automation, ensuring it is inserted in the housing of the arm support.
Insert the lid [E] and the two heads [F].
Slide Arm Opening in
5
SPRINT - IP1546
GB