Download MemoCam Zorro - Hardware Installation Manual

MemoCam Zorro - Hardware Installation Manual
Installing the Zorro Unit
MemoCam Zorro Circuit Board Locations
Interface
Description
Table 1: Main Terminal Block Connections
RELAY 2 S/W N.O
Programmable Output
Relay.
Interface
Description
POWER
CONNECTIONS
+12V
This relay is softwareactivated. When tripped, the
N.O. relay contact closes for a
pre-defined period (0-999 s)
that is user selectable.
Connects to the positive output
of the 12Vpower supply.
Used to switch on an external
device such as a video
recorder, light or siren.
GNDCommon power supply ground.
IN1
Programmable Input.
RELAY 1 PIR N.C
Connects to an auxiliary device
for external alarm triggers or
arm/disarm control.
PIR Detector Output Relay.
This relay is activated by the
PIR, and can be used to
activate an external alarm
device. When triggered by
detected movement, the relay
N.C. contact opens for 1.6
seconds (standard).
External Alarm Input.
Connects to an auxiliary device
for external alarm triggers.
Use with GND-MAIN (Pin 2)
RS-485 PORT
Serial Communication Port.
Connects to a host using R+,
R-, T+ and T- terminal blocks.
19