Download INSTALLATION MANUAL - ADSF

Lift the profile up until it
comes to a stop
Move towards the support profile
Push the screw upwards
Turn clockwise
Place the motorization in the support profile
-2 sliding leaves: IN THE CENTRE
- 1 right opening sliding leaf: ON THE LEFT
100:200
- 1 left opening sliding leaf: ON THE RIGHT
100:200
6.15 fasten the brackets to the arms
- Release slightly the countersunk M6x12 screws, which the brackets have
been attached, to move one of the moving leaves. When M6 nuts, used to
attach the bracket are located within the arm rail, fasten the M6 countersunk
screws with a size 4 Allen wrench.
- Move the 2 loose-leaves until they meet, then fasten the other bracket, to the
other arm, perform the same operation and carry out a manual check of the
movement for the leaves to the end of the course.
11
Slightly
loosen
Tighten