Download User Manual

Turning the meter on/off
Push the S-button longer than 3 seconds to power on your
smartLAB®sprint meter without the use of a test- or check strip.
The meter carries out a quick self-test: all digits and symbols are
visible on the display and a double signal tone appears. After that,
the meter switches to measuring mode. To turn off the meter while
in measuring mode, push the S-button longer than 3 seconds. During the shut down process, the current year flashes on the display,
until it turns off.
Setting date, time and measuring unit
When inserting or replacing the batteries, date, time and the
measuring unit have to be set again, if the displayed values are not
correct. Carry out the following steps:
1. Enter setting mode
With the meter switched on, press
the S-button to enter the setting
mode. The currently set year is
shown on the display.
Note: If the year-, month-, day and time-settings are correct, you
can confirm these values by pressing the S-button.
16