Download User Manual - The Basic Roamer Company

RoamerTime+ User Manual
constant (percentage) amount. Whilst travelling to the next junction, perform an
adjustment. Although you are still travelling to the next junction, set the adjustment value to
the road book value for the next junction, but do not press T until you get there. This will
align the unit’s total distance display value to the road book at that junction and recalibrate
the unit for the following sections.
Remote Unit
The remote unit provides:



a red button on the left - which has the same effect as RT on the unit
a black button on the right - which has the same effect as B on the unit
a rocker switch that controls the trip meters and calibration value when driving the
measured distance.
The rocker switch simplifies the control of the distance displays/calibration value:



when depressed to the right, the distance displays/calibration value run forwards
when central, the distance displays/calibration value are paused
when depressed to the left, the distance displays/calibration value run backwards.
When a remote unit is connected, the directions of the distance displays/calibration value
cannot be changed via the front panel buttons - the position of the rocker switch takes
precedence. The distance displays/calibration value can only be paused using the remote
unit rocker switch.
The remote unit can be plugged directly into the unit or into the splitter box - see
Connections
© The Basic Roamer Company. All rights reserved.
www.thebasicroamer.co.uk
Page 31 of 36
Version 1.50 - Revision 0