Download User Manual - Opus Telecoms

Answer Call
The answer call button is used to answer a call on the endpoint. No parameters are required to
be set for this button. Please note this button will be greyed out when no call is currently ringing
on the endpoint.
Change Outgoing Caller ID
This changes the outgoing CLI that is presented when calls are made from this endpoint. The
features needs to be enabled on the telephone system and the CLI presented needs to be
allowed by the line provider.
Change Volume
The change volume button is used to increase or decrease the volume of the endpoint. The
parameters that can be set for this button are “Increase” or “Decrease”. The button can be used
to increase or decrease the alerting volume of the extension when the extension is currently not
on a call. When the extension is on a call the volume of the handset or headset will be increased
or decreased.
Clear Call
The clear call button will allow a call that is currently on the endpoint to be cleared. No
parameters are required to be set for this button. Please note this button will be greyed out
when no call is currently on the endpoint.
Do Not Disturb
The Do Not Disturb button can be used to place the extension into DND and if the extension is in
DND take it out of DND. The parameters that can be set for the DND button are the DND
message, these are the DND messages that are set on the phone system, these can be selected
from the drop down menu. The DND text is the custom DND text that can be placed beneath the
DND message on the extension.
Figure 10.10
Figure 10.11
The button on the toolbar will appear with a blue light at the bottom of the button when the
extension is in DND, as shown in Figure 10.11, and when the extension is not in DND will appear
with no light at the bottom of the button as shown in Figure 10.10. This gives the user a quick
graphical representation as to whether their extension is in or out of DND.
Dial Digits
The dial digits button is used to send digits to the endpoint. The parameters that can be set are
the digits to be sent to the endpoint. If this parameter is left blank then the user will be
prompted to enter the digits to be sent to the endpoint when the button is pressed. If the digits
parameter has digits in it these will be sent to the endpoint when the button is pressed.
Campaign Manager Record
This allows dialler records to be searched for and requires Campaign Manager Integration to be
enabled.
Xarios Phone Manager User Guide
3.0
Page 71 of 118