Download User Manual

Contents
Programming
1 Introduction.................................................................................................................................................. 5
1.1
Axis Definition ..................................................................................................................................... 5
1.2
Machine zero........................................................................................................................................ 5
1.3
Reference point ................................................................................................................................... 5
1.4
Coordinate System ............................................................................................................................. 5
1.5
Programming Coordinates ................................................................................................................ 6
1.6
Input Unit and Range of Coordinate ................................................................................................. 6
1.7
Program Configuration....................................................................................................................... 6
1.8
Tool Path of Rapid Positioning ......................................................................................................... 8
1.9
Offset of System Coordinate ............................................................................................................. 8
1.10
Initial and Modal of System.............................................................................................................. 8
1.11
Initial Status of System..................................................................................................................... 8
1.12
Start of Program ................................................................................................................................ 9
1.13
End of Program ................................................................................................................................. 9
1.14
Main Program and Subprogram...................................................................................................... 9
1.15
Backlash Compensation ................................................................................................................10
1.16
R Reference Plane...........................................................................................................................10
2 S, T, M Function, D, H, F, FEED%............................................................................................................11
2.1
S Function ..........................................................................................................................................11
2. 2
T Function .........................................................................................................................................11
2.3
M Function (Auxiliary Function)......................................................................................................11
2.4
D, H Function .....................................................................................................................................13
2.5
F, Feed%.............................................................................................................................................13
3 G Function (Preparatory Function).........................................................................................................14
3.1
G Function for Defining Programming State of the System .......................................................14
3. 2
G0 Rapid Positioning (Modal, Initial) .............................................................................................14
3. 3
G1 Linear Interpolation (Modal)......................................................................................................15
3.4
G2, G3 Circular Interpolation (Modal).............................................................................................15
3. 5
G4 Dwell.............................................................................................................................................16
3. 6
G10 G11 Rough Milling in Concave Groove of Inner Circular ...................................................16
3. 7
G12 /G13 Finish Milling of Inner Circle..........................................................................................17
3. 8
G14 /G15 Fine Milling of Outer Circle ............................................................................................18
3. 9
G22 System Parameter Setting (Modal) ........................................................................................18
3.10
G23 Conditional Jump....................................................................................................................19
3.11
G27 Machine Zero Inspection........................................................................................................19
3.12
G28 Rapid Traverse to Reference Point via Middle Point..........................................................20
3.13
G31 Rapid Return to the R Reference Plane ...............................................................................20
3.14
G34/ G35 Rough Milling of the Rectangle–concave Groove.....................................................20
2