Download User's Manual

Transcript
Function-Codes Zoom Table
·F720~725 is used to record the latest three malfunction types and the corresponding frequency, current and
voltage at last malfunction.
Refer to Appendix 1(P55) for causes and countermeasures for any malfunction.
5.8
Analog signal Parameters
5.8.1
Analog signal Input
G
N
E
F
In mode of analog speed control, it is necessary to set the min and max input analog, and the
corresponding output frequency to secure a good speed control effect.
F800
Min Analog Input (V)
F801
Max Analog Input (V)
F807
Setting Range: 0.00~MIN(F801,10.00)
Setting Range: MAX(0.00,F800)~
10.00
Corresponding Frequency for
Min Analog (Hz)
F808
Corresponding Frequency for
Max Analog (Hz)
Setting Range: F112~F111
Setting Range: F112~F111
I
U
Mfr Value: 0.00
Mfr Value: 10.00
Mfr Value: 0.00
Mfr Value: 50.00
·Set min and max analogs as per actual input range of analog signal.
·The setting values of F807 and F808 decide proportion mode of analog adjustment change, as shown in Fig
5-12:
·MIN (F801, 10.00) refers to the smaller one of the two values between F801 setting value and 10.00.
·MAX (0.00, F800) refers to the bigger one of the two values between F800 setting value and 0.00.
H
Input Analog
F801
F800
F807
Input Analog
F808
F801
Corresponding
frequency
F800
F807
F808
Corresponding
frequency
Fig 5-12 Proportion Mode of Analog Adjusting
5.8.2
Pulse Frequency Input
F809
Max Input Pulse Frequency (Hz)
Setting Range:0~9999
43
Mfr Value: 5000