Download Movifit-SC - Operating Instructions

Transcript
Electrical Installation
Power bus connection examples
5
5.8.2
Power bus with Han-Modular® plug connector
TIP
This example applies for the following connection boxes:
Power distribution
and line protection
•
•
Han-Modular®-ABOX "MTA...-H12.-...-00"
Han-Modular®-ABOX "MTA...-H22.-...-00"
•
SEW-EURODRIVE recommends using HARTING Power S products for power bus
project planning.
•
Two lines of max. 6 mm2 can be routed in the AC 400 V 50/60 Hz and DC 24 V
supply cable.
•
The spur lines leading to MOVIFIT® have a cross section of 4 mm2 and are a
maximum of 1.5 m long.
•
The Han Power S distributor is available from Harting (part number 6104 202 1069).
812456203
•
Supply sensor, group IV (24V_S)
In the connector of the Han Power S distributor mentioned above (part number
6104 202 1069), the 24V_S supply voltage of sensor supply group IV is jumpered
with 24V_C continuous voltage.
Accessories:
Harting provides the following accessories for the Han Power S distributor.
Type
Cable diameter
Part number
at Harting
Bushing seal for small entry
7-10 mm
0912 000 9965
10-13 mm
0912 000 9966
13-16 mm
Filler plug for small entry
Bushing seal for large entry
7-10 mm
0912 000 9969
10-13 mm
0912 000 9970
13-16 mm
0912 000 9971
16-19 mm
0912 000 9972
19-22 mm
Filler plug for large entry
78
0912 000 9967
0912 000 9968
0912 000 9973
0912 000 9974
MOVIFIT®-SC Operating Instructions