Download Kontron User's Guide

Transcript
KTD-S0044-G
Page 35
15.5
Onboard Status LEDs
15.6
Real-Time Clock Battery Connector
Power Supply
An external battery is only needed if time and date should be saved when the board turns off. The battery
interface uses the pin header J600 (2 pins).
Header
1
Note:
2
Pin
Signal
Description
Type
1
GND
Ground
PWR
2
VBAT3 1)
Battery input voltage +3V
PWR IN
1) To protect the external power lines of peripheral devices make sure that
- the wires have the right diameter to withstand the maximum available current.
- to enclosure of the peripheral device fulfills the fire-protecting conditions of IEC/EN 60950.
1
2
J600
KTT20/pITX User's Guide