1
Download USER'S GUIDE
Transcript
2. Using Non-contact Door Switch ■ Wiring Example G9SX-NSA: Manual reset, Cross fault detection mode: OFF (Category 2 Wiring), Logical AND connections: OFF, OFF-delay time setting Section Setup (For details, refer to Section 3.) 1 Application Examples Wiring Example Actuator Feedback Loop Non-contact Door Switch S2 +24V KM1 11 Motor controller KM2 S3 12 KM1 S1 KM2 blue Brown Black White +24V NC NC A1 S14 T11 T12 T21 T22 T31 T32 T33 Y1 D1 D2 D3 D4 NC NC AND T41 T42 OFF M1 G9SX-NSA222-T03 +24V Control circuit A2 S14 S24 S44 S54 L1 X1 X2 KM1 KM2 GND PLC etc. Motor controller (Operation command) S1 : Emergency Stop Switch S2 : Non-contact Door Switch S3 : Reset switch KM1, KM2 : Contactor M1 : 3-phase motor Note: This example corresponds to category 2. ■ Timing chart Emergency Stop Switch operation Emergency Stop Switch S1 Non-contact Door Switch S2 Reset switch S3 KM1, KM2 NC contact KM1, KM2 NO contact Operation command Rotation of motor OFF-delay time OFF-delay time G9SX USER'S GUIDE 21
