Download Operating Instructions VEGAPULS 62

9 Diagnosis, asset management and service
This status message is inactive by default. It can be activated by the
user via PACTware/DTM or EDD.
Failure
The following table shows the error codes in the status message
"Failure"andgivesinformationonthereasonandrectification.Keep
in mind that some information is only valid with four-wire instruments.
Code
Cause
Rectification
F013
– Sensor does not detect an
echo during operation
– Antenna system dirty or
defective
– Check or correct installation
and/or parameter adjustment
– Clean or exchange process
component or antenna
F017
– Adjustment not within
specification
– Change adjustment according to the limit values (difference between min. and
max.≥10mm)
F025
– Index markers are not con- – Checklinearizationtable
tinuously rising, for example – Delete table/Create new
illogical value pairs
F036
– Failed or interrupted software update
–
–
–
–
F040
– Hardware defect
– Exchanging the electronics
– Send instrument for repair
F080
– General software error
– Disconnect operating voltagebriefly
F105
– The instrument is still in the
start phase, the measured
value could not yet be
determined
– Wait for the end of the
switch-on phase
– Duration depending on
the version and parameter
adjustment up to approximately 3 min.
F113
– EMC interference
– Transmission error with the
external communication
with 4-wire power supply
unit
– RemoveEMCinfluences
– Exchange 4-wire power
supply unit or electronics
F125
– Temperature of the elec– Check ambient temperature
tronicsinthenon-specified – Isolate electronics
range
– Use instrument with higher
temperature range
F260
– Error in the calibration carried out in the factory
– Error in the EEPROM
Text message
no measured
value available
Adjustment
span too small
Error in the
linearization
table
No operable
software
Error in the
electronics
General software error
Determine
measured
value
40793-EN-140922
Communication error
Impermissible electronics
temperature
Error in the
calibration
VEGAPULS 62 • HART and accumulator pack
Repeat software update
Check electronics version
Exchanging the electronics
Send instrument for repair
– Exchanging the electronics
– Send instrument for repair
51