Download Operating Instructions (Basic) AC Servo Motor & Driver
Transcript
9. Dynamic Brake Outline This driver is equipped with a dynamic brake for emergency stop. Pay a special attention to the followings. Caution 1.Dynamic brake is only for emergency stop. Do not start/stop the motor by turning on/off the Servo-ON signal (SRV-ON). Otherwise it may damage the dynamic brake circuit of the driver. The Motor becomes a dynamo when driven externally and short circuit current occurred while dynamic brake is activated may cause smoking or fire. 10. Check of the Combination of the Driver and the Motor Incremental Specifications, 20-bit This driver is designed to be used in a combination with the motor which are specified by us. Check the series name of the motor, rated output torque, voltage specifications and encoder specifications. Caution Power supply 3-phase, 400V Do not use in other combinations than those listed below. Type MSME Low inertia Motor Rated rotational speed 3000r/min • You can activate the dynamic brake in the following cases. 1) when the main power is turned off 2) at Servo-OFF 3) when one of the protective function is activated. 4) when over-travel inhibit input (NOT, POT) of connector X4 is activated In the above cases from 1) to 4), you can select either activation of the dynamic brake or making the motor free-run during deceleration or after the stop, with parameter. 3-phase, 400V 2000r/min 3-phase, 400V MFME Middle inertia 2000r/min 3-phase, 400V MGME Middle inertia 1000r/min 3-phase, 400V Note − B44 − MDME Middle inertia MHME High inertia 2000r/min Model Rated output MSME084G1* MSME104G□* MSME154G□* MSME204G□* MSME304G□* MSME404G□* MSME504G□* MDME044G1* MDME064G1* MDME104G□* MDME154G□* MDME204G□* MDME304G□* MDME404G□* MDME504G□* MFME154G1* MFME254G1* MFME454G1* MGME094G□* MGME204G□* MGME304G□* MGME454G1* MHME104G□* MHME154G□* MHME204G□* MHME304G□* MHME404G□* MHME504G□* 750W 1.0kW 1.5kW 2.0kW 3.0kW 4.0kW 5.0kW 400W 600W 1.0kW 1.5kW 2.0kW 3.0kW 4.0kW 5.0kW 1.5kW 2.5kW 4.5kW 0.9kW 2.0kW 3.0kW 4.5kW 1.0kW 1.5kW 2.0kW 3.0kW 4.0kW 5.0kW Model MDDHT2412 MDDHT3420 MDDHT3420 MEDHT4430 MFDHT5440 MFDHTA464 MDDHT2407 MDDHT2412 MDDHT3420 MEDHT4430 MFDHT5440 MFDHTA464 MDDHT3420 MEDHT4430 MFDHTA464 MDDHT3420 MFDHT5440 MFDHTA464 MDDHT2412 MDDHT3420 MEDHT4430 MFDHT5440 MFDHTA464 Frame D-frame E-frame F-frame D-frame E-frame F-frame D-frame E-frame F-frame D-frame F-frame D-frame E-frame F-frame • Suffix of “ □ ” in the applicable motor model represents design order. • Suffix of “ * ” in the applicable motor model represents the motor structure. − B45 − English 2.Dynamic brake is a short-duration rating, and designed for only emergency stop. Allow approx. 10 minutes pause when the dynamic brake is activated during high-speed running. Driver