Download Installation manual

SPANNTOP [nova] – Disassembly
1. Put the machine tool in set up mode.
2. Disassemble the base end-stop [see section »Disassembling the base end-stop«].
3. From weight 15 kg mount the eye bolts [see section »Unpacking and inner-company transport«].
WARNING!
Danger of injury due to vertical suspended
spindle!
Bending into the machine work are when assembling overhead can cause severe head injuries.
 Secure components prior to overhead assembly.
 For assembly on a vertically suspended spindle always use a suitable mounting aid.
Fig. 68
4. Vertically suspended disassembly:
 Place the assembly plate [illustration is symbolic]
on the tool turret.
 In jog mode, move the spindle slowly and carefully downward until the clamping unit touches
the assembly plate.
 Loosen and remove the cylindrical screws using
an Allen wrench.
 Turn the clamping unit counterclockwise so that it
comes out of the machine spindle. If required,
slowly and carefully move the machine spindle
upward.
 When the clamping unit is completely disassembled, move the machine spindle completely upward.
 Use a crane to take the clamping unit with drawtube adapter off of the assembly plate.
 Remove the assembly plate from the tool turret.
5. Horizontal or vertical standing disassembly:
 Loosen and remove the cylindrical screws by using an allen wrench.
Fig. 69
Order Hotline +49 7144.907-333
69