Download User manual Interroll

ConveyorControl
Planning
Out 1, Out 2 and Relay
ID
Name
POUT1
This tab includes the parameters for the outputs of the ComControl in the
terminal box.
Meaning
Value range
Default
setting
LogicType
Output type
(only with Out 1 and Out 2)
PNP
(cannot be set)
PNP
POUT2
SwitchType
Switch type
Normally open
Normally closed
Normally
open
POUT3
Function
Function assignment
Not used
Error signal
Aux RD start*
Zone status
Sensor signal
Input signal 2
Input signal 3
Not used
POUT4
SignalDelay
Signal delay
1 – 10 s in 0.1 s increments
0 = no delay
0
* Output is switched parallel to RollerDrive.
CentralControl
The CentralControl must not be parameterized, the parameters can merely be
read out.
ID
Name
Meaning
Value range
Default
setting
PG1
ControlMode
Central or decentralized
conveyor control
Cannot be set
Decentralize
d
NodeID
Numbering
Cannot be set
–
ProductKey
Article number of the module
Cannot be set
–
Serial
Serial number of the module
Cannot be set
–
40
Version 2.0 (04/2013) en
Translation of the original instructions